Supported products:

FileDescriptionFile sizeLast modified
Download this file (node_history.txt)Firmware HistoryHistory of previous changes0.3 kB1月 11, 2017
Download this file ( version v1.0.0.4 B1-23+3.6.1 for Windows 10PC Updater752 kB1月 11, 2017


  • The firmware update has to be done on a PC running Windows 10 when the device is connected to the computer via Thunderbolt.
  • This firmware is only for AKiTiO products and specifically the model(s) as mentioned above. DO NOT use this firmware for any other devices!


  • Never turn off or disconnect your unit during the firmware update procedure. This may damage your device! If the upgrade fails (e.g. power failure during firmware update), you may not be able to operate your device anymore.


How to update the firmware

  1. Download the firmware utility, save it on your local disk and unzip the file.
  2. Connect the device to your computer via Thunderbolt and turn on the power.
  3. Wait until the device has been recognized by the system and then double-click the *.exe file to start the update.
    node fw update 01
  4. Select the device "inXtron, AKiTiO Node" and click Next.
    node fw update 02
  5. Wait for the update to finish and make sure not to turn off the power or disconnect the device while the update is still in progress.
    node fw update 03
  6. When the update has been completed successfully, click on the X in the top right corner to close the program.
    node fw update 04
  7. Safely eject the device from your system and turn off the power.
  8. Restart it to complete the firmware update procedure.


  • If the firmware utility was unable to recognize your device, following error message will appear. Please make sure that the power is turned on, reconnect the Thunderbolt cable and then click OK to try it again.
    node fw update 05